Dunrovin Station: A Gnother Gnome

Doc here.

During the winter break, I decided to create 3D wall art of Baard the Gnome.

I started by printing the line-art that Caryl had created for her Etsy shop to create graphite rubbings for the general outline. The body is formed by halving a length of 1x12 and using a thickness planer to reduce the two halves down to about ¼". While it would've been nice to make the resaw cut in a single pass on the bandsaw, the wood's width was too great -- so I made two passes on the table saw.

Several passes through the thickness planer brought the pieces down to ¼" thick.

I then made the graphite rubbings on each of the two pieces and cut out the layers of Baard's body using the bandsaw.

When I rubbed the outlines onto the layers, I also marked three points by punching the pencil through through the paper to mark holes to drill on the drill press.

Two of the holes are drilled all the way through the back layer and partway into the front layer for dowels to align the two layers. The third hole is drilled all the way through both layers to position Baard's nose.

Then I used the strip sander to make the final touch-ups to the layers' outlines and to partially round the edges.

On to Baard's hat. At first approximation, it's a triangle, but the sides are slightly curved, and the bottom edge has a pronounced curve. The front of the hat is a curved surface. I wanted the lower corners to be at the same level as the body's front layer and the middle of the base to project about a half-inch from the front layer, which would be the full thickness of the original 1x12. The peak of the hat should be slightly shallower than the body's front layer.

I started with a graphite rubbing and then cut a triangle. The reason I started with straight sides instead of starting with the bandsaw was so I could make bevel cuts to start shaping the front surface. By running the triangle's sides along the tabletop, the resulting bevel faces will leave the base thicker in the middle than the sides, and the sides and peak will all be at the same level.

After using the bandsaw to introduce the slight curves on the hat's sides and the pronounced curve on the base, I used the belt sander to finish shaping the hat's front from a collection of flat facets to a single curved surface. Finally, I used some scraps from forming Baard's body to extend the thickness of the hat's sides so the hat appears to fully enclose Baard's head.

I cut out Baard's nose from the 1x12 and gave it an initial pass at rounding it with a ⅜" roundover bit on the router table. I further rounded it with the strip sander.

The strip sander left Baard's nose faceted, and so I finished rounding it using a sanding sponge.

Baard's shoes were daunting at first glance.

I decided to start with a scrap of 2x3 and used Forstner bits to cut the concave curves first. I cut a dado down the middle of the 2x3 and then cut the 2x3 down the middle of the dado, creating the two shoes -- each half of the dado is now a rabbet to attach the shoe to Baard's body.

I used the bandsaw to cut the convex surface at at the bottoms of the shoes, and then I free-handed a rough oval shape from top to front to bottom to back. I touched-up the shaping on the strip sander and, as with the nose, removed the faceting with a sanding sponge.